Please SUBSCRIBE: https://bit.ly/3e8Hz7t
——————————————————
Total Happy Up And Sunny by Sascha Ende
Link: https://filmmusic.io/song/555-total-happy-up-and-sunny
License: http://creativecommons.org/licenses/by/4.0/
Tuesday by Sascha Ende
Link: https://filmmusic.io/song/2992-tuesday
License: http://creativecommons.org/licenses/by/4.0/
——————————————————
We would like to support all companies or people to promote their products, service, or company. If you need our support, don’t hesitate to contact us via email wowtv2050@gmail.com.
If you are a copyright video owner and don’t want us to use it in this video, please contact us via email wowtv2050@gmail.com. We make sure to remove your video immediately.
Thanks for your co-operation.
source
Let's see it make a dodecahedron with another three inside, followed by a Icosahedron with another two inside…made out of brass with sharp internal and external vertices.
Amazing compilation!
I will not go within ten miles of a lathe after hearing about that video of a guy dying from one, thank you very much
Great technology and great machine
This is Incredible !
https://youtu.be/hXbN9vnCEBs watch this amazing work
Send one to Pakistani space research institute so they can build a space shuttle ??
Is very good
Super sir
#MechanicalUpdate
#MachanicalUpdate
Largest lathe I have seen could chuck up a piece of stock 96" in diameter.
6 fit ret
I need stuff like this made in so cal so badly. Don’t know where to start.
Hanzhen harmonic gear , strain wave reducer, robot arm gear , over 30 years experience
?
https://youtu.be/I3x2Yz7WmD0
please spill the program
nice
junge es gibt eien fräßmaschine der erste clip tut mir als zerspanungsmechaniker in en augen weh
There's a vid of a guy getting guy getting absolutely abbliterated by this thing it's pretty cool to see a human move in such a fast way and losing all your organs
Not satisfying!!
3つ爪で四角形作れることすら知らんかった
….and if you asked any Co to do that simple task it would take them 6 fkn months at a prohibited cost,…eye candy.
5:58 the video you were looking for
GEC as was, had very large diameter lathes for armature shaft machining.
It sure would be nice if you put your in video links at the very end of the video after it has played. That way I don’t miss anything.
Ohhhwow X machine
공작기계의 발전 대단합니다
감탄 감탄 멋집니다 ?
Not the biggest I've ever seen! Used to run 100" with 60' bed niles… rode the carriage..
That first clip was god mode on a lathe?
Beautiful 🙂
4:07 mmmm, Lathe pron. The way that thing slide over the part and the way the part was cut away MmmHmmm….