Hooking a Hobart 27i into a Langmuire Crossfire CNC plasma with diagrams and how to save $200!

This past month I’ve been building a CNC Plasma table from Langmuire. The most worrysome part was opening a brand new $1400 plasma cutter to add a firing cable. Here I show the wiring diagram. Explain where to tap in. Prove the correct wires. Prove they’re hooked up correctly, plug into the CNC test fire, Then cut my first parts.

Savings!
Save $100+ off the Hobart 27i (Its even cheaper now $150 off!)
https://store.cyberweld.com/hobart-airforce-27i-plasma-cutter-500575.html
I saved $100 off the CNC with this defunct Youtubers coupon code: WORKSBYAHURST (his channel is now a corporate channel with only sponsored videos, coupon code may still work though. Please update me if not)

https://www.langmuirsystems.com/

0:00 Intro
0:25 Wiring diagram
0:45 Locating wires
1:40 Static warning!
2:00 Back probing wiring to verify
2:40 Wire installed
3:30 CNC break-in
4:00 Double checking cable
4:50 Test fire
5:10 Cutting and outro

source