Check out the full video on this project – https://youtu.be/To6YGYFAfnU
Here are the plans if you want to make these yourself – https://www.toolstoday.com/wooden-jack-o-lantern-cnc-plans.html
Cutting a pumpkin face on the Stepcraft M.1000 CNC machine using the Amana Tool #46176-K 1/8″ Spektra™ coated compression bit all linked below
– – – – – – –
RPM: 18,000
Feed Rate: 40ipm
Plunge Rate: 20ipm
Depth per pass: .25″
#short #shorts
Tools Used:
STEPCRAFT M.1000 CNC Machine
https://www.toolstoday.com/stepcraft-m-1000-cnc-system.html
– – – – – – –
Design Software – Vectric V-Carve Pro –
https://www.toolstoday.com/cnc-machines-accessories/cnc-software.html
– – – – – – –
Amana Tool 46176-K CNC SC Spektra Extreme Tool Life Coated Compression Spiral 1/8 D x 13/16 CH x 1/4 SHK x 2-1/2 Inch Long Router Bit
https://www.toolstoday.com/v-14528-46176-k1.html
** Subscribe – https://www.youtube.com/user/toolstoday
** Shop the website – http://www.toolstoday.com
source
Check out the full video on this project – https://youtu.be/To6YGYFAfnU
Here are the plans if you want to make these yourself – https://www.toolstoday.com/wooden-jack-o-lantern-cnc-plans.html
Beautiful I also router Lerner
What bit would you advise, to cut a 5mm oval shaped pocket in clear epoxy ? will be putting a picture in it then recovering with epoxy.Thanks
What program do you use?
Why the slight curved start on both triangles. It seems redundant to start in the middle & spiral out, rather than just do the three cut lines of the triangle.
So nice art I like it