Budget DIY CNC Plasma Cutter || Motion and Controls

1. Soo cool

2. This is gonna be sweet any help on an electronic box where did you guys get your from got a link maybe

3. You should make your own screws with a rod and a tap and die set

4. this is nice. in my area steel prices make this competely out of reasonable cost range sadly. pretty much had to abandon all my projects because of it too

5. Also what code are you using?

   Gcode?

   Do you need to flash the ardunio?

   I'm looking at getting a laser cutting and running a relay off the laser output…

   But this option looks good Also.

   I have nema23 motors with 8mm shafts and 8mm bore pulleys for gt2 15mm belts.

   I haven't got a board or drivers yet.

   I was looking at buildbotics, but my knowledge towards turning the cutter on and off is non existent.

   I do cnc router and 3d printing.

   I have a shapeoko pro xxl and cr10-max as reference to what I'm capable of achieving.

   Any advice or direction would be great

   My budget is what I can make back as profits.

6. How are you turning the plasma cutter on and off?

7. Whats the effective cutting size on table

8. At that kind of speed a “tip-up” could be catastrophic. Lol. However, nice build. I went a little different route with mine. (Just recently found your channel). Great explanations and content. Thanks!

9. Someone yall know have a Langmuir Systems table bc this looks like a clone minus the belt drive. If i didnt use firecontrol id probably convert mine to belt drive.

10. heyya guys!, absolutely loving what you guys are coming up with, the budget engineering is genius! bought some plans and its coming along awesome! just a heads up with the metric plans, we're down in AUS and without importing at great expense we cant get 70mm tube for the gantry spacer, we can get 65 or 75mm as standard sizes. wasn't too bad to make a 75 into a 70. but i thought id give some feedback. keep doing what you're doing! thanks again!

11. what is the working space????

12. Do you have the links for the electronic parts?

13. Are you using GRBL?

14. Nice job. Love the simplicity of it.I Like what I saw so much I ordered your plans and 3d parts.

15. i would pay for a parts list on a website or somthing realy clean design the belt tesioning and expexialy the drive motor position is remarkable

16. Any chance you could link to the components that you used? That would be very useful IMHO.

17. Keep it going great job !

18. Cool ? lookin good!

19. Hola amigo, muy buen trabajo el q has realizado, que tan posible es que puedas proporcionar unos planos? Incluso el del los carros, Felicitaciones…

Comments are closed.